This product is suitable as a localised ‘problem solver’ for cold external walls and is not recommended for use in fire escape routes inside your home unless the surface is further treated with a fire retardant covering. This product is class E fire rated and should not be used for projects such as new builds and extensions where Building regulations are applicable. I would also think that, once it's adhered properly on that wall, it ain't going to shift easily. So, follow the instructions carefully, and allow PLENTY of time to ensure the proper adhesive has fully set. When used in isolation this product is suitable as a localised ‘problem solver’ for cold external walls and is not recommended for use in fire escape routes or on ceilings.

Great surface for paint or paste-the-wall wallpapers (read more below if you'd like to use paste the paper wallpapers) I applied the System Adhesive to walls using a medium pile roller, using a brush around skirting and ceiling where the roller wouldn't “reach”, making sure there was plenty of adhesive on the wall where I used the brush – i.e. I didn't brush it out.For each roll you’ll need between 7.5 and 10 kgs of the adhesive depending on how absorbent the surface is A. Two main reasons, 1) It makes it much easier to achieve a nice neat finish with minimal filling and sanding 2) It helps protect your investment from damage creating a good base for paint or decorative wallpaper at the same time. Your husbands concerns about cavity wall insulation have a valid basis. It can in some cases cause serious problems with penetrating damp, condensation and corrosion of wall ties. A noticeable increase in energy efficiency – the room certainly doesn’t get cold as fast when the heating turns off

Mould Prevention - Thermal Liner allows walls to breathe and raises the room temperature meaning it will help to combat mould growth Thermal liner is classified as „E “according to DIN EN 13501-1 in relation to its reaction to fire behaviour, which corresponds to „B2“(normally inflammable) according to the standard DIN 4102-1 We'd not recommend putting ceramic tiles over the thermal liner. If you want to hang ceramic tiles over the thermal liner, please use the Professional Insulation Panels instead.This product is suitable as a localised ‘problem solver’ for cold external walls and is not recommended for use in fire escape routes inside your home unless the surface is further treated with a fire retardant covering. This product is class Efire rated andshould not be used for projects such as new builds and extensions where Building regulations are applicable.

Q. I remember those old polystyrene insulation tiles that were a real fire hazard, so I have worries in this regard about Thermal Liner? A. The roll are extra wide so each roll will cover 7.5 m2 or 121 ft2. Please use the link below to calculate the square meterage you may require, you will need to select Klimatec Thermovlies on the scroll menu. http://www.erfurt.com/cms/en/advisor/advisormain/calculation.html

Fibreliner Smooth 150

Make sure you always apply the adhesive with a medium pile roller and use a brush for the corners, top and Bottom.

You probably need to look at slightly larger render companies to do the work as they are more likely to have previous experience. The efficiency measurement of an actual material is called the Lambda. The higher the Lambda rating the more efficient it is and as a result will require less energy or heat to feel warm an cosy. This rating is measures in Watts / Meter x Kelvin. You do need as PigletJohn says to consider window reveals/eaves etc otherwise you end up with fat walls that don't work where there is a detail.If you are applying thermal liner & KV600 over plaster base, lightly sand then PVA bond 2 times to seal the wall.If you are applying over painted plaster, lightly sand then PVA bond to seal the wall. Only paste the wall enough for 1 strip at a time leaving it wider to make sure the edges are covered and to reduce the amount on adhesive that will be applied for the next strip on the edges.