HB Body 222 Bumpersoft Car Body Filler Black Putty For Plastic Bumpers 250g With Hardener Excellent Adhesion Easy To Sand With P120-P240

Product Information

Sand the repair area level, first with 80 grit sandpaper and then with a fine grain sandpaper to smooth it out. If needed, apply another light layer of filler over any gaps or dips to restore the original contours.

The filler is supplied complete with the necessary fast epoxy hardener which will cure the filler in around 2hrs. Prepare surfaces. Surfaces should be close fitting (pre-fit before joining), free of residue, and dry. Slightly roughen smooth surfaces to improve results. Once hardened, finish the sanding with wet fine grit sandpaper for a really smooth finish and wipe away any dust.Remove the masking tape and sand down the damage at the front to make the area a little low and create a rough surface for bonding. Apply bonding liquid if supplied. It depends on whether you choose rigid plastic strips or flexible plastic strips as to how bendable the plastic strip will be.

Prepare adhesive and activator (if applicable). Open the adhesive and, if relevant, the activator according to the manufacturer’s instructions. After any paint repair, it’s best to wax the car, preferably professionally to keep the paint in the best condition. Wait at least a week after the repair before waxing. Depending on the nature of your project you need to consider the width of the plastic flat strip that you need. The smallest width of plastic (PVC) flat bar strips range is 6mm and the widest is 142mm. Can be used from 15 to 30°C although pot-life and cure time will be affected significantly. Recommended working at an ambient of 20-25°C. If you require thin plastic strip take a look at our range and see if we have a suitable size. It is possible for us to manufacture thin strips of plastic to other specifications but this would be custom production so is subject to much larger production runs, normally around 2000 metres. The minimum production runs would vary depending on the size of the profile and can be quoted upon request. uPVC strips - an explanationRigid PVC strips are manufactured from a different material to our flexible plastic strips and we encourage you to request samples if you are unsure which material to choose. This material is different to our rigid plastic strips and we encourage you to request samples if you are unsure which material to choose. Solid plastic strips Apply adhesive. Apply it sparingly to one surface and press the parts together immediately. Hold in place until the bond sets. Do not reposition parts.

You are very welcome to request samples of PVC strip if you are unsure about exactly which plastic flat strip you need. You may wish to see the colour, the different type of material, the width or the edge style. Our plastic flat strips are manufactured in PVC and are solid all the way through, both in terms of material and colour. We get asked sometimes if our flat strips are foiled, with the colour just being on the surface of the product. They are not foiled, they are high quality products and are a solid colour all the way through. Bendable plastic strips Spacers and gap fillers, as the plastic strips can sit between two edges or slide underneath an edge to fill a gap.Apply activator (if applicable). If you are using an activator, apply it to both surfaces unless otherwise indicated. Wait until it has dried completely, then proceed with the adhesive. Stay safe. Work in a well-ventilated, protected area. Wash your hands when you are finished, and optionally wear gloves for extra protection. Apply a liberal amount of repair material to the damaged area so that you make the surface a little higher than surrounding bumper. Use a spreader like a squeegee to carefully smooth out the filler. Make sure to push the filler into any scratches to fill them right to the bottom. Cover with smoothing film if supplied and allow to dry and fully harden.