Amtech NC-559-V2-TF No-Clean Tacky Flux USA (30cc)

Product Information

No-clean” indicates that the product requires cleaning method as defined by IPC no-clean standard and does not mean that the flux leaves no residue. Fully translucent thick rosin-rich solder chemistry leaves clear residue easy to evaporate with hot air, cleaned using isopropanol, industrial solvents, ultrasonic scrubbers, or vapor degreasers. Stellar soldering performance, long work time, non conductive even before activation and relatively inexpensive compared with other branded fluxes. If you've created a bridge, need to solder a jumper in a small area, or are reflowing a chip to try and remove corrosion - good flux will make your life easier.

I'm looking for a tacky flux, something like Amtech, but can't seem to find a decent seller anywhere in Europe.Do note these are heavily counterfeited in China, so if you're after one, you've been warned (seems the innards don't always work). Liability is expressly disclaimed for loss or injury arising out of use of this information or the use of any materials designated. sorry, but my knowledge of Russian is nihil, so maybe the maker of the video tells something which can explain his tests! Syringes are intended for industrial dispensing machines and use a piston stopper instead of a plunger - do not remove the piston as it delivers the best seal to prevent contact with air.

be/iKDAmY9Rdag, I wasn't that much wiser than before (although I didn't know that liquid flux evaporates thaaaat fast, this is why I wanna go for tacky/paste flux). I would not say that makes it a bad choise - it simply makes it a more unpredictable choise in terms of what to expect. When it comes to soldering Sn60/Sn62/Sn63 leaded MT alloys using Hot Air station the V2 formulation would be one of the first choices for the handcraft/hobby/rework - V2 chemistry instantly wets Sn/Pb MT alloys but most importantly it has sufficient body to withstand rework with Hot Air station for extended period of time. Highly praised by advanced reworks community for mighty long-lasting action and easy cleaning - clear residue evaporates with hot air and doesn't short components.

VS-213A-TF retains all greatly admired AMTECH's no-clean context - industrial wetting capabilities, optimal tack/viscosity, long lasting performance, clear residue, easy cleaning, and signature AMTECH pine scent.

I mean if I purchased a product with a fake label, it's really my fault for not doing my homework well enough to spot the difference.The information contained herein is based on data considered to be accurate but does not purport to be all-inclusive and shall be used only as a guide. A plunger is to push on the piston and not necessary snuggly fitting air syringe, a plunger can be loose.